Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
detail: Add g_ prefix to can_dlc_to_len and len_to_can_dlc to
follow NuttX coding style conventions for global symbols,
improving code readability and maintainability.
Signed-off-by: zhaohaiyang1 <zhaohaiyang1@xiaomi.com>
We can see them in ifconfig:
ap> ifconfig
wlan0 Link encap:Ethernet HWaddr 42:64:7f:b3:12:03 at UP mtu 1500
inet addr:10.0.1.2 DRaddr:10.0.1.1 Mask:255.255.255.0
inet6 DRaddr: ::
RX: Received Fragment Errors Bytes
00000b9b 00000000 00000000 21daf5
IPv4 IPv6 ARP Dropped
00000a33 00000137 00000031 00000000
TX: Queued Sent Errors Timeouts Bytes
00000ac4 00000ac4 00000000 00000000 1a2103
Total Errors: 00000000
Signed-off-by: meijian <meijian@xiaomi.com>
Add TUNSETCARRIER ioctl, then we may change the carrier state of TUN dynamically. Note that we don't need an ioctl for getting carrier, it can be done by SIOCGIFFLAGS already.
Ref: https://github.com/torvalds/linux/blob/v6.10/drivers/net/tun.c#L3374-L3380
Signed-off-by: Zhe Weng <wengzhe@xiaomi.com>
"/home/guoshichao/work_profile/vela_os/vela_car_4/nuttx/include/nuttx/net/netdev.h", line 493: warning #231-D:
declaration is not visible outside of function
FAR struct netdev_ifaddr6_s *addr,
^
Signed-off-by: guoshichao <guoshichao@xiaomi.com>
Summary:
1. use nuttx/atomic.h instead of stdatomic
2. remove CONFIG_HAVE_ATOMIC,because we now support atomic on all platforms
Signed-off-by: chenrun1 <chenrun1@xiaomi.com>
optimize the interaction flow associated with network drivers to reduce
the amount of code and improve compatibility
Signed-off-by: zhanghongyu <zhanghongyu@xiaomi.com>
- use 'lan9250_ioctl' to set and get the value of lan9250 phy register
- use `lan9250_uninitialize` to un-initialize the ethernet driver
Signed-off-by: chenwen@espressif.com <chenwen@espressif.com>
This definition was added in order to solve some compilation problems
encountered when porting third-party libraries
Signed-off-by: zhanghongyu <zhanghongyu@xiaomi.com>
Some drivers may set too big quota by accident and consume all of our
buffers, so we add a check when registering devices.
Signed-off-by: Zhe Weng <wengzhe@xiaomi.com>
Also extend the "struct phy_desc_s" to support for 1GB PHY's, the speed
detection always needs more than one bit.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
Support longest prefix match routing described as "Longest Match" in
RFC 1812, Section 5.2.4.3, Page 75.
Introduced `prefixlen` to indicate the prefix length of currently
founded route, and only looks up for longer prefix in all later steps.
Signed-off-by: Zhe Weng <wengzhe@xiaomi.com>
Add a static port-based VLAN configuration for KSZ9477 switch. This doesn't
use the VLAN tagging, but is a switch's internal mechanism to simply configure
if the packet forwarding is allowed from one port to another.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
-The qemu wifi fucntion only supports the STA mode and the following
operations:
wapi mode wlan0 2
wapi scan wlan0
wapi psk wlan0 password 3
wapi essid wlan0 wifi_name 1
wapi show wlan0
wapi disconnect wlan0
-Eanble the virtual wifi function with the MACRO `CONFIG_DRIVERS_WIFI_SIM`.
Signed-off-by: liqinhui <liqinhui@xiaomi.com>
Previously ipv6 multi-address support decided packet source
address based on its destination. This doesn't work if NuttX
device has multiple addresses within same subnet.
Instead when a packet is a response to existing connection,
the source address should be based on the destination address
used in the received packet.
Adds support for timestamping received UDP packets, either in
hardware or in kernel. Builds on the existing support of SO_TIMESTAMP
for SocketCAN.
Implementation uses CLOCK_REALTIME for timestamping to match the
behavior of Linux. This could be made configurable in future if needed.
1. Supporting `SIOCSIFADDR` and `SIOCDIFADDR` with Linux in6_ifreq struct to manage ipv6 addresses.
Ref: https://man7.org/linux/man-pages/man7/netdevice.7.html
2. Supporting alias like 'eth0:0' for multiple IPv6 addresses, to keep previous ioctl `SIOCGLIFADDR`, `SIOCSLIFADDR`, `SIOCGLIFNETMASK` and `SIOCSLIFNETMASK` working.
Ref: https://man7.org/linux/man-pages/man8/ifconfig.8.html
Signed-off-by: Zhe Weng <wengzhe@xiaomi.com>
Note that user-space related code, like procfs and lifreq related ioctl commands, are not touched in this commit.
Signed-off-by: Zhe Weng <wengzhe@xiaomi.com>
