walnux/include/nuttx
Anthony Merlino 14fb37c995 Merged in antmerlino/nuttx/sixlowpan-mac802154 (pull request #526)
ieee802154: Simplifies notify() and rxframe() calls to a single notify() call. dataind's and all other "notifs" are now "primitives" which aligns with standard terminology

* mac802154: Adds missing breaks from case statement

* sixlowpan: Fixes bad logic where ACK is not requested if address is not a broadcast

* ieee802154: Simplification of "notifs" and "datainds" to generic primitives passed via a single notify call to the layer above the MAC

* Directories.mk should reference CONFIG_WIRELESS instead of CONFIG_DRIVERS_WIRELESS

* xbee_netdev: Network must be locked when calling sixlowpan_input

* sixlowpan: Reassembly buffer can't be freed if provided by radio driver

* sixlowpan: Don't free IOB if there is an error processing it as the MAC will try to pass it along to another receiver

* ieee802154: Adds basic logging to ieee802154_primitive.c

* Minor fixes after rebase

* xbee: Adds AT query timeout to retry if XBee doesn't respond to request

* same70-xplained: Adds Xbee support. Makes mikroBus slot Kconfig 'choice'

* mac802154: Removes unused function declaration

* drivers/mrf24j40: Fixes compilation error using . operator rather than -> operator

* mac802154_device: Changes a few mac802154_primtive_free's to ieee802154_primitive_free() and changes notif to primitive in a couple places.

* mac802154: Adds promiscous mode logic to bypass parsing of incoming frames. MAC char device also checks for promiscous mode and passes whole frames including header and FCS to the application if promiscous mode is enabled.

* sixlowpan: Fixes logic to correctly check if packet is large enough to include header.  This would cause packets to be considered too small when they are sufficiently sized.

* sixlowpan: Fixes forwarding logic to use forwarding device rather than received device to look up destination link layer address

* net/ipforward: Fixes typo that caused build error when IP forwarding was enabled with CONFIG_NET_ICMPv6_NEIGHBOR enabled as well.

* configs/same70-xplained: Simple spelling fix

Approved-by: Gregory Nutt <gnutt@nuttx.org>
2017-11-01 20:15:21 +00:00
..
analog Merged in juniskane/nuttx_stm32l4/stm32l4_adc_kconfig_pr (pull request #478) 2017-09-06 22:05:44 +00:00
audio drivers/audio: Fix naming of configurations to be compliant for vs1053 audio driver. 2017-08-24 11:11:06 -06:00
binfmt Documentation and comments updated to further enshrine exec() as an official NuttX interface. 2017-10-03 07:52:05 -06:00
can MCP1515: Eliminate some warnings 2017-06-14 09:38:58 -06:00
contactless Add an instance argument to the SPIDEV definitions. 2017-04-29 12:26:52 -06:00
crypto Add entropy pool and strong random number generator 2017-03-30 07:38:37 -06:00
drivers Move SMPS driver to drivers/power (and header to include/nuttx/power). Rename debug to IOCTLs to more general power naming; create a separate file to coordinate power-related IOCTL commands. 2017-07-23 07:35:09 -06:00
eeprom
fs fs/userfs: Some fixes from initial testing. 2017-10-31 15:26:58 -06:00
i2c Changes from review of PR 114 2016-08-14 13:38:47 -06:00
input Merged in hardlulz/modem-3.0-nuttx/fix-stmpe811-gpio (pull request #523) 2017-10-31 16:54:28 +00:00
ioexpander drivers/ioexpander: The IRQ subsystem now supports passing a void * parameter to IRQ handlers. Use that method to support multiple pc9555 devices, by passing a pointer to the device to the board defined irq handler. Now the CONFIG_ for multiple PCA devices just allocates device structures dynamically instead of statically when not enabled. 2017-10-19 08:10:40 -06:00
lcd drivers/lcd: ssd1306: add support for board power control. ThingseeOne has regulator for controlling display power on/off. Patch adds support for board based power control to SSD1306 driver. 2017-08-22 08:40:27 -06:00
leds Add driver for APA102 LED controller. These LEDs are used on LED Strips and are controlled over SPI. 2017-09-18 16:48:55 -06:00
lib libm: Port gamma() and lgamma() from FreeBSD to NuttX. 2017-08-08 07:02:39 -06:00
mm PF_IEEE802154: Finishes up sendto() logic 2017-08-19 12:32:56 -06:00
modem include/nuttx/modem: Move all modem-related IOCTL commands to a common file to assure that they will be unique 2016-09-16 09:39:51 -06:00
mtd There was a reference counting problem in the TPC logic of net_clone(). net_clone() which is the common logic underlying dup() and dup2() for sockets. When net_clone() calls net_start_monitor() and net_start_monitor() returns a failure (because the underlying TCP connection) then net_clone() must back out the reference count on the structure. Problem noted by Pascal Speck and this implementation of the solution is based on his suggestion. 2017-10-19 11:09:23 -06:00
net drivers/net: Remove the old, unfinished Crystal LAN driver. I don't even have the hardware that it goes with anymore. 2017-10-28 10:27:00 -06:00
nx Update a document, a README, and some comments. 2017-10-17 06:25:46 -06:00
power Merged in raiden00/nuttx (pull request #503) 2017-10-08 19:13:12 +00:00
sensors drivers/sensors/apds9960.c: Use work_queue to read/process data when receive an IRQ 2017-10-20 08:54:44 -06:00
serial Squashed commit of the following: 2017-07-28 12:01:05 -06:00
spi include/: Remove dangling space at the end of lines. 2017-06-28 13:30:08 -06:00
syslog include/: Remove dangling space at the end of lines. 2017-06-28 13:30:08 -06:00
timers Merged in juniskane/nuttx_stm32l4/stm32l1_stm32l4_rtc_update_pr (pull request #514) 2017-10-20 17:15:17 +00:00
usb drivers/usbdev: Add RNDIS-over-USB driver 2017-09-24 07:24:34 -06:00
video Fix some typos in comments; Fix some bad spacing in fb.h 2017-09-18 09:03:26 -06:00
wireless Merged in antmerlino/nuttx/sixlowpan-mac802154 (pull request #526) 2017-11-01 20:15:21 +00:00
.gitignore
addrenv.h
arch.h Move prototype from nuttx/include/nuttx/arch.h to apps/include/platform/cxxinitialize.h 2017-05-13 16:53:55 -06:00
ascii.h
board.h boardctl(): Remove the BOARDIOC_GRAPHICS_SETUP command. 2017-10-15 07:56:04 -06:00
cancelpt.h task: Add new cancellation point interface, check_cancellation_point(). 2017-10-09 09:43:04 -06:00
clock.h Be consistent... Use Name: consistent in function headers vs Function: 2017-04-21 16:33:14 -06:00
compiler.h compiler.h: Fix some GCC warnings introduced for SDCC support. Basically a naming collision. 2017-10-02 07:09:31 -06:00
init.h
irq.h Add missing endif 2017-03-03 14:39:35 -06:00
kmalloc.h
kthread.h kthread_create(): Rename kernel_thread() to kthread_create() for better naming consistency with task_create() and kthread_delete(). 2017-10-16 11:38:00 -06:00
mmcsd.h Add capabilities() method to SDIO interface. Remove CONFIG_SDIO_WIDTH_D1_ONLY. That should not be a global propertie, but rather a capability/limitation of single slot when there may be multiple slots. 2017-01-31 09:16:01 -06:00
module.h Module names are not needed in libc/modlib when the module library is used only for shared library support. 2017-01-29 12:23:24 -06:00
mqueue.h mqueue.h edited online with Bitbucket 2017-10-11 02:49:20 +00:00
page.h
pgalloc.h
poff.h Fix names of pre-processor variables used in header file idempotence 2016-08-06 19:21:42 -06:00
progmem.h
pthread.h Move cancellation point definitions to their own header file. 2016-12-10 09:08:26 -06:00
random.h Be consistent... Use Name: consistent in function headers vs Function: 2017-04-21 16:33:14 -06:00
sched.h sched: move POSIX thread specific data from pthread TCB to common TCB structure. This change allows using pthread_getspecific/pthread_setspecific from main thread. Patch also enables using pthread data with config option CONFIG_DISABLE_PTHREAD=y. 2017-10-25 07:06:42 -06:00
sched_note.h Update ChangeLog in prep for 7.20 release. 2017-03-08 10:09:48 -06:00
scsi.h
sdio.h sdio.h:Fix typos 2017-08-17 09:33:34 -10:00
semaphore.h libc and libnx: When the libraries are built into two libraries, a user space library and a OS space library (as in the PROTECTED and KERNEL build). Then the user space library must not use the OS internal interfaces; similarly, the OS must avoid using the userspace interfaces so that it does not muck the errno value or create spurious cancellation points. 2017-10-08 12:14:18 -06:00
signal.h libc and libnx: When the libraries are built into two libraries, a user space library and a OS space library (as in the PROTECTED and KERNEL build). Then the user space library must not use the OS internal interfaces; similarly, the OS must avoid using the userspace interfaces so that it does not muck the errno value or create spurious cancellation points. 2017-10-08 12:14:18 -06:00
spawn.h
spinlock.h SMP: There were certain conditions that we must avoid by preventing releasing the pending tasks while withn a critical section. But this logic was incomplete; there was no logic to prevent other CPUs from adding new, running tasks while on CPU is in a critical section. 2016-12-27 08:49:07 -06:00
streams.h Syslog buffering: Use IOBs to buffer data, not an on-stack buffer 2017-05-10 17:36:08 -06:00
symtab.h
time.h Be consistent... Use Name: consistent in function headers vs Function: 2017-04-21 16:33:14 -06:00
tls.h
tree.h include/: Remove dangling space at the end of lines. 2017-06-28 13:30:08 -06:00
userspace.h
vt100.h
wdog.h Update some wdog-related comments 2017-02-24 10:58:37 -06:00
wqueue.h work_queue() must cancel existing work prior to queuing new work, otherwise the work queue can become corrupted. Problem noted by Pascal Speck. 2017-08-28 07:46:48 -06:00
zoneinfo.h include/: Remove dangling space at the end of lines. 2017-06-28 13:30:08 -06:00