ds28e17.h edited online with Bitbucket
2018-04-05 12:08:56 +00:00
drivers/analog: Add driver for digital to analog converted DAC7571.
2018-08-02 06:40:48 -06:00
Adds loopback test for digital MIC on lc823450 via i2schar driver.
2018-06-05 10:34:22 -06:00
binfmt/: Mostly cosmetic changes from review of a previous commit.
2018-08-24 06:10:50 -06:00
arch/arm/src/samv7: Add ability for CAN BUS_OFF autorecovery according ISO11898-1:2015. With this change we added an ioctl for triggering the autorecovery sequence for BUS_OFF to the CAN-driver and the SAMV7 low-level driver. According the datasheet: If the device goes Bus_Off, it will set MCAN_CCCR.INIT of its own accord, stopping all bus activities. Once MCAN_CCCR.INIT has been cleared by the processor (application), the device will then wait for 129 occurrences of Bus Idle (129 * 11 consecutive recessive bits) before resuming normal operation. At the end of the Bus_Off recovery sequence, the Error Management Counters will be reset. During the waiting time after the resetting of MCAN_CCCR.INIT, each time a sequence of 11 recessive bits has been monitored, a Bit0 Error code is written to MCAN_PSR.LEC, enabling the processor to readily check up whether the CAN bus is stuck at dominant or continuously disturbed and to monitor the Bus_Off recovery sequence. MCAN_ECR.REC is used to count these sequences.
2018-07-04 07:48:59 -06:00
Add an instance argument to the SPIDEV definitions.
2017-04-29 12:26:52 -06:00
Make sure that labeling is used consistently in all function headers.
2018-02-01 10:00:02 -06:00
This commit adds a 1wire subsystem.
2018-04-04 10:57:36 -06:00
drivers/eeprobom: EEPROM driver for AT24xx compatible EEPROMs.
2018-02-14 07:53:01 -06:00
include/nuttx/fs/hostfs.h: Update duplicated definitions in HOSTFS that must match NuttX values.
2018-07-09 05:44:48 -06:00
Update some comments
2018-08-03 09:30:31 -06:00
Make sure that labeling is used consistently in all function headers.
2018-02-01 10:00:02 -06:00
configs/stm32f103-minimum: Remove nonsensical #error.
2018-01-09 11:17:01 -06:00
Remove trailing spaces at the end of lines.
2018-08-13 07:39:38 -06:00
Squashed commit of the following:
2018-07-22 15:13:39 -06:00
libm: Port gamma() and lgamma() from FreeBSD to NuttX.
2017-08-08 07:02:39 -06:00
mm/: add mm_heapmember function and reimplement kmm_heapmember base on mm_heapmember since this function is very useful if multiple heaps exist.
2018-08-23 09:38:49 -06:00
include/nuttx/modem: Move all modem-related IOCTL commands to a common file to assure that they will be unique
2016-09-16 09:39:51 -06:00
/include/nuttx/mtd/configdata.h: Fix copy-paste comment in configdata.h
2018-05-08 09:09:47 -06:00
Rename devif_loopback_out to devi_loopback
2018-08-25 08:33:21 -06:00
Make sure that labeling is used consistently in all function headers (part 3).
2018-02-01 12:17:03 -06:00
Merged in raiden00/nuttx (pull request #668 )
2018-07-07 17:04:57 +00:00
drivers/sensors and configs/nucleo-l476g: Add support for LSM303AGR and LSM6DSL sensors
2018-08-25 08:19:31 -06:00
Squashed commit of the following:
2018-08-26 11:37:16 -06:00
include/nuttx/spi/spi.h: Add a definition for a USBHOST SPI device. drivers/usbhost/usbhost_max3421e.c: Review and correct SPI locking usage.
2018-07-04 08:55:43 -06:00
syslog: Enable is partial, crippled version of syslog_flush(); arch/: Call syslog_flush() from assertion handling logic.
2018-06-07 16:29:16 -06:00
drivers/timers: Add a new method to the struct oneshot_operations_s interface to get the current time from a oneshot timer driver (if it is available from the lower half)
2018-08-24 10:21:29 -06:00
drivers/usbdev/cdcecm.c: Adds USB Device Support for CDC/ECM
2018-08-16 08:49:11 -06:00
Fix lots of typos in C comments and Kconfig help text
2018-07-08 18:24:45 -06:00
Add missing function names in function headers.
2018-08-13 15:53:15 -06:00
Move include/nuttx/mm.h to include/nuttx/mm/mm.h
2014-09-24 07:29:09 -06:00
Rename CONFIG_ARCH_HAVE_TRIGGER_HOOK to CONFIG_ARCH_HAVE_IRQTRIGGER
2018-08-25 09:10:30 -06:00
ASCII: Improve some naming
2016-04-14 16:20:36 -06:00
This commit eliminates the BOARDIOC_TSCTEST_SETUP command.
2018-01-17 09:33:28 -06:00
Make sure that labeling is used consistently in all function headers.
2018-02-01 10:00:02 -06:00
include/nuttx/clock.h, sched/sched: Support the CPU load measurement using timer_lowerhalf_s interface
2018-08-24 10:10:57 -06:00
Squashed commit of the following:
2018-08-24 08:30:01 -06:00
fs/proc and sched/environ: Add support for a procfs entry that will permit examining the environment of any task.
2018-08-10 10:16:39 -06:00
enter/leave_critical_section: In SMP configuration, may attempt to access the task lists before they have been initialized
2016-05-18 09:17:01 -06:00
sched/irq: Add support interrupt chains in NuttX. IRQ chain is very useful in these cases: (1) Multiple hardware connect to the same request line(e.g. PCI), (2) Need multiple driver to support one hardware block (like Linux MFD)
2018-08-24 15:10:23 -06:00
Squashed commit of the following:
2018-08-24 08:30:01 -06:00
Update some comments. Remove references to non-existent CONFIG_MAX_TASK_ARG.
2018-08-08 17:06:46 -06:00
Add capabilities() method to SDIO interface. Remove CONFIG_SDIO_WIDTH_D1_ONLY. That should not be a global propertie, but rather a capability/limitation of single slot when there may be multiple slots.
2017-01-31 09:16:01 -06:00
Module names are not needed in libc/modlib when the module library is used only for shared library support.
2017-01-29 12:23:24 -06:00
Make sure that labeling is used consistently in all function headers.
2018-02-01 10:00:02 -06:00
Add basic data structures that will allow us to move named semaphore support out of the OS and into the VFS (not complete).
2014-09-28 10:15:33 -06:00
mm/mm_gran: Add a function to get information about the state of the granuale allocator.
2017-11-14 14:41:03 -06:00
Fix names of pre-processor variables used in header file idempotence
2016-08-06 19:21:42 -06:00
progmem interface: Discern r/w and erase page sizes. Introduce new up_progmem_erasesize architecture API to be able to communicate the read/write page size independently from erase page size. Implement up_progmem_erasesize for all architectures that already support progmem, assuming that for those architectures the sizes of both read/write and erase pages are identical.
2018-05-01 06:23:52 -06:00
pthreads: Add support static pthread stack. Add standard pthread_attr_setstack() and pthread_attr_getstack(). In all cases where the stack is released, add check to see which allocator must be used to free the stack: The user or the kernel allocator.
2018-08-23 09:49:20 -06:00
Standardization of some function headers.
2018-03-13 09:52:27 -06:00
arch/ and task/sched: vfork operation needs to allocate and copy the task argument too. Also correction of the address correction cannot depend on the stack pointer since it is not available in all architectures. Rather callculate the offset from the stack allocation pointer
2018-08-24 07:43:00 -06:00
Update ChangeLog in prep for 7.20 release.
2017-03-08 10:09:48 -06:00
Clean up and review of header files for conformance to standards
2015-06-12 19:26:01 -06:00
drivers/mmcsd/Kconfig: three configuration settings were within ifdef/endif and led to warning: xxx selects xxxx which has unmet direct dependencies. Fix by moving settings to drivers/Kconfig and outside of the ifdef-endif. Also renamed CONFIG_SDIO_PREFLIGHT to CONFIG_ARCH_HAVE_SDIO_PREFLIGHT to follow naming of similar hidden architecture capability configurations.
2018-08-05 17:58:17 -06:00
Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t
2018-06-16 12:16:13 -06:00
Fix lots of typos in C comments and Kconfig help text
2018-07-08 18:24:45 -06:00
armv7-a, armv7-r, armv7-m: Add atomic read-add-write and read-subtract-write functions.
2018-02-04 12:22:03 -06:00
Make sure that labeling is used consistently in all function headers.
2018-02-01 10:00:02 -06:00
Modules: Add mod_setsymtab to set global symtol table once. Now we can remove symbol table parameters from the insmod call. This will make implementing an NSH insmod command much easier
2015-12-13 08:10:01 -06:00
Make sure that labeling is used consistently in all function headers.
2018-02-01 10:00:02 -06:00
TLS: Simplify
2016-03-11 07:17:32 -06:00
include/: Remove dangling space at the end of lines.
2017-06-28 13:30:08 -06:00
Make sure that labeling is used consistently in all function headers.
2018-02-01 10:00:02 -06:00
Add ANSI/VT100 color codes
2014-11-10 15:10:57 -06:00
Standardization of some function headers.
2018-03-13 09:52:27 -06:00
sched/wqueue, libs/libc/wqueue, configs: Remove work queue polling delay to simplify the code logic and save the power.
2018-08-25 14:58:07 -06:00
include/: Remove dangling space at the end of lines.
2017-06-28 13:30:08 -06:00
ead2c40cd4