ds28e17.h edited online with Bitbucket
2018-04-05 12:08:56 +00:00
drivers/analog/lmp92001.c: Add support for the TI LMP92001 device.
2018-12-21 09:46:33 -06:00
Fixes warnings from header files:
2018-11-09 09:10:28 -06:00
binfmt/libelf, libs/libc/modlib: Optimize elf load speed: (1) Don't zero out memory, (2) Reduce the initial buffer size to 32 bytes.
2019-01-26 11:34:40 -06:00
arch/arm/src/samv7: Add ability for CAN BUS_OFF autorecovery according ISO11898-1:2015. With this change we added an ioctl for triggering the autorecovery sequence for BUS_OFF to the CAN-driver and the SAMV7 low-level driver. According the datasheet: If the device goes Bus_Off, it will set MCAN_CCCR.INIT of its own accord, stopping all bus activities. Once MCAN_CCCR.INIT has been cleared by the processor (application), the device will then wait for 129 occurrences of Bus Idle (129 * 11 consecutive recessive bits) before resuming normal operation. At the end of the Bus_Off recovery sequence, the Error Management Counters will be reset. During the waiting time after the resetting of MCAN_CCCR.INIT, each time a sequence of 11 recessive bits has been monitored, a Bit0 Error code is written to MCAN_PSR.LEC, enabling the processor to readily check up whether the CAN bus is stuck at dominant or continuously disturbed and to monitor the Bus_Off recovery sequence. MCAN_ECR.REC is used to count these sequences.
2018-07-04 07:48:59 -06:00
Add an instance argument to the SPIDEV definitions.
2017-04-29 12:26:52 -06:00
This change:
2018-12-19 08:42:48 -06:00
Merged in raiden00/nuttx_pe (pull request #779 )
2018-12-09 16:31:57 +00:00
drivers/eeprom/i2c_xx24xx.c and include/nuttx/eeprom/i2c_xx24xx.h: Add support to Microchip AT24CM02
2018-12-30 11:20:03 -06:00
Fix condition logic: The setup seems to support a network without sockets. That is not the case.
2019-02-11 15:47:25 -06:00
include/nuttx/i2c/i2c_master.h: Fix a small typo.
2018-12-07 18:53:57 -06:00
drivers/timers/oneshot.c: Support signal notification through SIGEV_THREAD
2019-01-27 08:53:12 -06:00
sched/signal and related changes to other OS subsystems.
2019-01-27 09:28:59 -06:00
drivers/timers/oneshot.c: Support signal notification through SIGEV_THREAD
2019-01-27 08:53:12 -06:00
Squashed commit of the following:
2018-07-22 15:13:39 -06:00
binfmt/libelf, libs/libc/modlib: Optimize elf load speed: (1) Don't zero out memory, (2) Reduce the initial buffer size to 32 bytes.
2019-01-26 11:34:40 -06:00
mm/iob/iob_notifier.c: Don't check iob_navail in iob_notifier_setup to avoid a potential race condition.
2019-01-26 09:43:54 -06:00
include/nuttx/modem: Move all modem-related IOCTL commands to a common file to assure that they will be unique
2016-09-16 09:39:51 -06:00
Extends the MTD configdata device with the following features / additions:
2018-12-20 14:14:40 -06:00
include/nuttx/net/netdev.h: Update some comments.
2019-02-25 19:20:29 -06:00
include/nuttx/nx/nxmu.h: This header file coul be lethal; it declared an #error if CONFIG_DISABLE_MQUEUE=y.
2019-02-04 18:45:09 -06:00
drivers/power/pm_activity.c: Add pm_staycount API for get stay numbers. This function is currently not used and a waste of FLASH space.
2019-01-27 11:19:26 -06:00
drivers/timers/oneshot.c: Support signal notification through SIGEV_THREAD
2019-01-27 08:53:12 -06:00
include/nuttx/serial/uart_16550.h: Fix warning: 'struct file' declared inside parameter list.
2019-01-27 11:22:40 -06:00
Merged in raiden00/nuttx_lora (pull request #821 )
2019-01-20 13:03:11 +00:00
Squashed commit of the following:
2019-02-04 16:20:35 -06:00
drivers/timers/timer.c: Support the signal notification through SIGEV_THREAD
2019-01-28 06:32:27 -06:00
Updates from coding standard review of PRs 753 and 754
2018-11-09 07:44:22 -06:00
Fix lots of typos in C comments and Kconfig help text
2018-07-08 18:24:45 -06:00
Merged in raiden00/nuttx_lora (pull request #829 )
2019-02-24 17:58:46 +00:00
Squashed commit of the following:
2019-03-04 14:22:50 -06:00
ASCII: Improve some naming
2016-04-14 16:20:36 -06:00
Let's rename board_driver_initialize() to board_early_initialize() to emphasize its relationship to board_late_initialize().
2019-02-18 16:25:08 -06:00
Make sure that labeling is used consistently in all function headers.
2018-02-01 10:00:02 -06:00
ched/clock/: Remove g_monotonic_basetime and g_clock_monotonic_time since we don't need ensure monotonic time start from zero as state here: http://pubs.opengroup.org/onlinepubs/009696899/functions/clock_getres.html
2018-11-12 06:50:37 -06:00
include/poll.h and include/nuttx/compiler.h: Update some comments; improved a conditional test.
2019-02-21 18:06:53 -06:00
Merged in antmerlino/nuttx/elf-cplusplus-guard (pull request #826 )
2019-02-19 15:24:25 +00:00
fs/proc and sched/environ: Add support for a procfs entry that will permit examining the environment of any task.
2018-08-10 10:16:39 -06:00
binfmt/ and libs/libc: Make exepath_*() more common:
2018-11-08 07:27:14 -06:00
Squashed commit of the following:
2019-02-04 16:20:35 -06:00
include/nuttx/irq.h: Fix enter_critical_section/spin_lock_irqsave macro typo error and remove the duplicated inclusion of arch/irq.h
2019-01-27 11:21:03 -06:00
include/nuttx/kmalloc.h: Add {kumm/kmm}_calloc API. Add calloc API for manage user memory and kernel memory in Flat Build/Kernel Build without kernel heap.
2018-08-27 05:55:09 -06:00
Update some comments. Remove references to non-existent CONFIG_MAX_TASK_ARG.
2018-08-08 17:06:46 -06:00
include/nuttx/list.h: Fix some typos.
2019-01-29 07:37:22 -06:00
Add capabilities() method to SDIO interface. Remove CONFIG_SDIO_WIDTH_D1_ONLY. That should not be a global propertie, but rather a capability/limitation of single slot when there may be multiple slots.
2017-01-31 09:16:01 -06:00
Module names are not needed in libc/modlib when the module library is used only for shared library support.
2017-01-29 12:23:24 -06:00
nuttx/sched/mqueue: Change 'int prio' to 'unsigned int prio'. According to open group specification, priority field in mq_* functions should have unsigned type: http://pubs.opengroup.org/onlinepubs/9699919799/basedefs/mqueue.h.html
2019-02-15 19:18:55 -06:00
include/nuttx/mutex.h: Add inline wrapper functions to more clearly support semaphores when used as mutexs.
2018-08-27 06:26:11 -06:00
Kconfig: Move 'option modules' from NSH_FILE_APPS to BUILD_LOADABLE
2018-08-27 07:06:57 -06:00
mm/mm_gran: Add a function to get information about the state of the granuale allocator.
2017-11-14 14:41:03 -06:00
Fix names of pre-processor variables used in header file idempotence
2016-08-06 19:21:42 -06:00
Merged in ebsong/nuttx (pull request #722 )
2018-09-21 03:18:38 +00:00
pthreads: Add support static pthread stack. Add standard pthread_attr_setstack() and pthread_attr_getstack(). In all cases where the stack is released, add check to see which allocator must be used to free the stack: The user or the kernel allocator.
2018-08-23 09:49:20 -06:00
Standardization of some function headers.
2018-03-13 09:52:27 -06:00
Fix condition logic: The setup seems to support a network without sockets. That is not the case.
2019-02-11 15:47:25 -06:00
Update ChangeLog in prep for 7.20 release.
2017-03-08 10:09:48 -06:00
Clean up and review of header files for conformance to standards
2015-06-12 19:26:01 -06:00
This commit adds a new function arch_invalidate_dcache_by_addr(). It takes the same parameters as arch_invalidate_dcache(), but performs invalidation of only the lines in cache that need to be invalidated. This new function could be used as a a direct replacement for arch_invalidate_dcache().
2018-11-20 14:03:42 -06:00
include/nutt: Fix definitions used to access OS functions within the libraries. In the FLAT build, we must always set the errno and/or create cancellation points because the same library functions are used within the OS as are used by applications. This could cause issues for the OS but corrects some problems at the user interface.
2018-09-26 06:58:08 -06:00
sched/signal and related changes to other OS subsystems.
2019-01-27 09:28:59 -06:00
Squashed commit of the following:
2019-03-04 14:22:50 -06:00
Restore lib_sprintf(). It was removed because I thought was not used. But I was wrong; there is logic in drivers/syslog that depends on lib_sprintf().
2019-02-16 12:29:00 -06:00
arch/arm/src/samd2l2 serial: Fix SAMD2L2 serial driver it needs sam_usart_enable() to work
2019-01-26 12:51:51 -06:00
Make sure that labeling is used consistently in all function headers.
2018-02-01 10:00:02 -06:00
TLS: Simplify
2016-03-11 07:17:32 -06:00
include/: Remove dangling space at the end of lines.
2017-06-28 13:30:08 -06:00
This commit renames all internal OS functions defined under sched/task so that they begin with the prefix. For example, nxtask_exit() vs. task_exit().
2019-02-04 13:42:51 -06:00
Standardization of some function headers.
2018-03-13 09:52:27 -06:00
sched/wqueue/kwork_notifier.c and several Kconfig files: Notifier should work with either lpwork or hpwork and other minor typo fix.
2019-01-27 11:02:56 -06:00
include/: Remove dangling space at the end of lines.
2017-06-28 13:30:08 -06:00
5fe6981c9a